plumb

Plumb

Support

Answers to common questions about the level, the compass and tips.

Getting started

Lay your phone flat for the spirit level: two discs slide together as it comes level, and the screen lights up and clicks when it gets there. Stand it up against a wall, a frame or a door and the horizon takes over, with the reading measured from vertical or horizontal, whichever the phone is nearer.

Swipe sideways for the compass. Swipe up from the bottom, or tap the page dots, for Settings.

Calibrating the level

Phones aren’t perfectly level inside, and a camera bump tilts them further, so a new phone can read a little off. Plumb measures its own error with a half turn: lay it flat on any table, and when it asks, turn it around, about 180°, and keep it still. The table doesn’t need to be level, because the two readings cancel its tilt out.

You can start a calibration any time from Settings: under Level, tap Calibrate. Calibrate once on each phone, and again after changing its case.

Degrees, slope, mm/m and in/ft

In Settings, choose how the level reads: degrees from level, slope as a percentage, millimetres per metre, or inches per foot. Each choice shows a live reading as you pick.

Slope in mm/m suits falls for drains, patios and paths; inches per foot is the way roof pitch is given in the US.

Holding a reading

Tap anywhere on the level to hold the reading, so you can read it back once the phone is in your hand. Tap again to let it go.

The compass and true north

True north is the north on maps; magnetic north is where a needle points, a few degrees away depending on where you are. To point to true north, Plumb needs your location, which it uses on your phone with the World Magnetic Model. Without it, the compass shows magnetic north. You can switch between the two in Settings.

Tap the compass to lock a bearing: the screen lights up when you’re back on it. Tap again to unlock it. Hold the phone up to read headings along the horizon. Your coordinates show at the bottom, and you can turn them off in Settings.

When the compass is off

A compass reads the Earth’s magnetic field, so metal, magnets, speakers, cables and magnetic phone cases nearby bend it. When something does, Plumb says so. Step away from it and try again.

If Plumb asks to calibrate the compass, tap Calibrate and sweep the phone through a figure-eight until it’s done.

Vibration

Plumb clicks when it reaches level. To turn the click off, switch off Vibration in Settings.

Tips

Every tool in Plumb is free. In Settings you can leave an optional one-off tip through Google Play or the App Store. Tips unlock nothing; they keep Plumb free.

If you reinstall Plumb, it restores past tips when it starts. You can also tap Restore tips at the bottom of Settings.

Accuracy and safety

Plumb shows tenths of a degree, and it’s as accurate as your phone’s sensors, its calibration and what’s around it. Don’t rely on it where a mistake could cause harm or damage, such as for navigation, surveying or structural work, and check anything important with a dedicated tool.

Languages

Plumb follows your phone’s language: English, German, Spanish, French, Italian, Dutch, Portuguese, Japanese, Korean, and Chinese, simplified and traditional.

Still stuck?

Email hello@tomuozawa.com with your phone’s model and the version shown at the bottom of Settings.